6
Installation
ADVICE!
You can find quick-start guides to selecting the lubrica-
tion rate on our homepage at www.jost-world.com.
Selecting a lubrication program:
Connect pin 2 to +24 V.
Apply operating voltage to pin 1 and pin 3.
Leave pin 2 connected to +24 V for another 15 seconds until
the LED starts flashing quickly (2 Hz).
Disconnect pin 2 from +24 V. The lubrication system is now
in Program mode. You can select the programs as shown in
the table. Example: Briefly connect pin 2 to +24V four times
to select Program 4.
When the lubrication system recognizes that program selec-
tion has taken place, the LED flashes at a rate of 1 Hz the
number of times of the chosen program number. After the
selected program has been displayed in this way, the lubrica-
tion system automatically switches to Lubrication mode.
6.3.5 Connecting the LubeTronic
5Point
for special lubrication
(optional)
Connect pin 2 to +24V using a button with NO contacts.
If possible, use a vehicle-specific button in the cab.
To trigger special lubrication, press the button for approx. 3 sec-
onds until the lubrication system acknowledges this via the func-
tion lamp (which lights up for 1 second). When special lubrication is
selected, 5 individual discharges of grease take place over a period
of approx. 20 minutes.
6.3.6 Connecting the LubeTronic
5Point
for status indication in
the cab (optional)
Connect pin 4 as shown in the circuit diagram in section 6.3.1
"Daimler/standard wiring diagram (4-pin connector)".
We recommend that you use vehicle-specific indicator lights from
the accessories.
14
MUB 002 009 M01
(REV-B)
07-2020
LubeTronic
5Point
