7
Operation
7.4
Fault indications
No. Fault
Cause
Remedy
1
Function lamp lights up continuously
after “ignition on”.
The grease supply in the grease tank has run
out.
Replenish the grease supply with LubeTronic
5Point
grease.
2
Function lamp flashes for 2 minutes
after “ignition on”. The function lamp
lights up continuously after 2 minutes
have elapsed.
The electronic control system of the LubeTronic
5Point
is damaged.
Check the connection of the LubeTronic
5Point
to the vehicle
power supply, see section 6.3.1 "Daimler/standard wiring diagram
(4-pin connector)" of this manual.
Check the connecting cable for damage and repair if necessary.
Check the routing of the connecting cable, see section 6.2 "Routing
the wiring harness" of this manual. The connecting cable must not
be crushed or stretched when the fifth wheel coupling is tilted (for-
wards or backwards). Replace damaged cables.
Check the LubeTronic
5Point
for damage and replace if necessary.
The vehicle’s type of use requires a higher lubri-
cation rate, e.g. construction vehicles.
Trigger special lubrication at regular intervals.
Shorten the breaks in the LubeTronic
5Point
lubrication program
by selecting a different lubrication program, see section 6.3.4
for a selective lubrication rate
Lubricant lines are damaged or crushed.
Check lubricant lines for damage and crushing and replace
any damaged or crushed lines. Use lines with a diameter of
4.3 x 0.65 mm for replacement.
Check the routing of lubricant lines, see section 5.3 "Fifth wheel
" of this manual. Lubricant lines
must not be crushed or stretched when the fifth wheel coupling is
tilted (forwards or backwards).
3
The LubeTronic
5Point
does not lubri-
cate sufficiently, or at all.
The grease supply has run out.
See fault 1 in this table.
EN
LubeTronic
5Point
MUB 002 009 M01
(REV-B)
07-2020
17
