2
Intended use
2.1
General
Locks R 403 FR and R 403 FL are not independently functioning
units. They are intended for mounting on a semi-trailer for trans-
porting ISO containers.
They must not be brought onto the market until it has been
established that the semi-trailer fitted with the locks satisfies the
domestic road traffic regulations.
The locks may only be brought into operation together with the
instructions in the owner’s manual of the tractor unit and trailer,
and the instructions for the locks themselves.
Locks R 403 FL and R 403 FR are used on the rear of a tipping con-
tainer chassis, for securing ISO containers. The R 403 FL is installed
on the left in the direction of travel, the R 403 FR on the right.
The lock components are reinforced, so that they can absorb the
loads acting on the tipping chassis during tipping.
The admissible loads can be found in the technical data, see
Chapter 2.2, "Technical data and spare parts".
We recommend fitting additional rear stabilisers, for use during
the tipping process.
2.2
Technical data and spare parts
ADVICE!
Test report 8109405693 from TÜV Nord Mobilität grants
approval based on ADR 2011 for a container weight of
34t.
WARNING!
The tipping angle must not exceed 55°. The maximum
admissible container weight when using this lock is 34t.
ADVICE!
Other combinations of container weight and tipping
angle may be approved following consultation with
JOST-Werke GmbH.
For spare parts numbers, please refer to the parts lists
of the latest product catalogue.
EN
Twist Locks R 403 Fx
MUB 013 005 M30
(REV-B)
07-2020
5
