JEB19 SAFETY INFORMATION
Ed.: 2019-R0
14
Always use high performance lubricants with Teflon additives specific to bicycle
transmissions, and compatible with the decorative elements of the frame and swingarm,
which are usually indicated on the labels as compatible with carbon frames.
DIRECTION LUBRICATION
Do not attempt to grease the steering bearings. The lubrication of the direction must be
done by your authorized dealer, it requires specific tools and knowledge.
REAR CHANGE REGULATION
This operation should only be carried out if you have adequate tools and the necessary
knowledge and practice. Otherwise, go to an authorized dealer.
- Regulation of the speed change path: It has two adjustment screws for the inner
and outer limits of the route. Turn the two screws so that the chain does not leave
its axial path. The change roller is aligned with the smallest sproket and the largest
sproket.
- Speed change adjustment: Place the gear change control in the second indication.
- Turn the adjusting screw of the cable tension until a perfect adjustment is achieved
on the second sproket.
- Check that the change acts correctly on all the cassette sprockets.
GEAR CHANGES USE
To avoid any mechanical problem (chain or change damage, pedaling noise, etc.), follow
these recommendations:
- Select the correct speed by changing just before the start of the climb or the
obstacle.
- When you intend to change speed, keep pedaling normally but without forcing, by
operating the shift lever until the chain is seated correctly on the sproket and the
selected plate.
- Avoid changing speed in full force, even if synchronized systems allow it in a hurry. It
is preferable to overexert or get off the bike.
