99744_UM_40S_G
22
9.
Orientate the two halves of the EPIRB the following way:
An orientation tab is fitted on both halves of the EPIRB,These tabs must be
placed carefully on top of each other.
10. Make sure that the gasket is properly in place, and replace the equator ring using
a special tool to tighten it together.
11. Replace the U-shaped bolt and a new split pin to secure the bolt in the equator
ring.
12. Remount EPIRB in its bracket.
6 . 1 . 3 B A T T E R Y D I S P O S A L
Dispose in accordance with applicable regulations, which vary from country to
country.(In most countries, the thrashing of used batteries is forbidden and the
end-users are invited to dispose them properly, eventually through non-profit
organizations, mandated by local governments or organized on a voluntary basis
by professionals).Lithium batteries should have their terminals insulated prior to
disposal.
6 . 1 . 4 I N C I N E R A T I O N
Incineration should never be performed by battery users but eventually by trained
professionals in authorized facilities with proper gas and fumes treatment.
6 . 1 . 5 L A N D F I L L I N G
Leachability regulations (mg/l)
Component
Leachability
EC limit
EPA
Other*
Iron
100
5
Nickel
100
500
2
0,5
* applicable to France
6 . 1 . 6 R E C Y C L I N G
Send to authorized recycling facilities, eventually through licensed waste carrier.
7.
Please make sure that the enclosed silicagel bag is fastened inside the emergency
product, with the supplied strips into/between holes in the black cover.
IMPORTANT: Cut the strips X-96898 after mounting of silicagel to avoid the
strips to come between rubber gasket and top housing.
8.
Please also fit the enclosed anti corrosion adhesive tape to the inside the battery
before assembly of the unit.
