Installation Instructions
On underneath of OEM bumper, remove
(9) 8mm bolts.
Install the Mounting Brackets behind the
OEM bumper support, being careful not
to damage the oil cooler.
Unsnap bumper from frame. Then
remove (2) 10mm bolts from top of
bumper that had been temporarily placed
earlier and set aside. Remove Lower
center grill and set aside.
When Mounting Brackets are in place,
secure through open holes in OEM
bumper support. Attach using provided
1/2”bolts and Stiffener Brackets.
Loosen (4) 10mm bolts from oil cooler
and leave loose. Attach Oil Cooler
Brackets onto OEM brackets.
Use provide (4) hex bolts, spacers, and
(4) hex nuts to re-install oil cooler on the
backside of Oil Cooler Brackets that it
was removed from.
Remove (7) 10mm bolts and (2) plastic
clips to remove the plastic cover. Set
aside. Temporarily replace (2) 10mm
bolts by hand to hold bumper before
removal.
For easier access to bolts you may want
to turn wheels. Then remove (4) 5mm
screws and then unsnap outer wheel
trim. Repeat for other side.
Remove exposed (1) phillips screw.
Repeat other side.
Continued on back...
