NRA Biometric Holster – Rev. 00 10.14.14
Page
3
AVK Installation Procedure for vehicle or metal surface
- Use QR Code
to right to view video sample of an AVK fastener installation, or you can
view at:
http://nrajottogear.gojotto.com/avk-fastener-installation-video
1.
The AVK fastener is designed to mount to metal surfaces only.
Prepare mounting area by pulling back carpet, padding or other
materials and marking where you will drill using the chosen
mounting bracket.
2.
Predrill pilot holes where you marked with 1/4” drill bit. Using the 25/64” drill bit, enlarge pilot
holes.
3.
Place 1/4"-20 x 1” long bolt though the 5/16” flange nut and hand thread bolt into the AVK fastener.
4.
Place into 25/64” drilled hole and use 1/2” box end wrench to secure the flange nut. Apply
downward pressure on the flange nut, pressing AVK fastener into hole. Using socket wrench,
tightened the 1/4"-20 x 1” bolt. This will the AVK fastener to expand and secure onto the backside
of the metal.
5.
REMOVE the 1/4"-20 x 1” bolt and flange nut to
repeat on second hole.
For Home Installations or non-metal
surfaces.
Due various surface types and
thicknesses, Customer should provide
own hardware to best secure
mounting bracket to selected
mounting surface.
Three different mounting brackets are provided to
maximize mounting position options. Choose a
secure surface when mounting bracket and mount.
After mounting bracket, use the provided security torx
bit in a universal driver to secure base of handgun
holster to mounted bracket with two provided 10-32
security screws.
Attach second biometric cable to handgun holster.
Save security torx bit and instructions for future
use.
Read and understand these instructions and the labels on the Jotto Gear Handgun Holster before using.
For Automotive installations, make sure the location you choose is free of all gas lines, brake lines, gas
tank, electrical and mechanical services.
