NRA Biometric Holster – Rev. 00 10.14.14
Page
7
Before Starting: Be sure to read and understand each step prior to attempting. Waiting too long in
between steps will cause the scanner to time out.
Erasing All Users Instruction
Performing this operation will erase all users including Master User and set unit
back to factory default.
Only Master User finger will be able to perform these steps.
Step1)
- Master User step
Press white program button on control unit.
Step 2)
- Master User step
Scan Master User finger to unlock firearms. Press white program button and wait 15 seconds for
ORANGE LED.
Step 3) - Master User step
During ORANGE LED, press and hold white button and hold Master User finger in place on the scanner
simultaneously.
Note: While holding finger and button in place, ORANGE LED will alternate to GREEN LED four times
followed by two series of six beeps and flashing GREEN LEDs.
During second series of beeps, remove hands from biometrics control unit and wait for unit to reset.
Step 4)
- Master User step
Biometrics will reset back to factory default. ORANGE LED will display, user should return to Page 17
for “Out-of-the-Box Instruction” on programming a new Master User.
If not scanning new Master User right away, remove batteries to turn off biometric control unit.
General Operation
Once programmed, sliding frame open will awaken
biometric control unit for approximately 20 seconds.
Press the white button to awaken biometrics control
unit.
Scan a programmed finger to unlock for firearm
retrieval. The lock should remain open for
approximately 8 seconds before auto-locking.
The biometric control unit will light during unlocking
period.
This light will remain on for approximately 15 seconds
before turning off.
