20
6.2 Replacing the side plates
Aluminium or glass sides
1. Undo
the
screws
(Fig.19 A)
holding the brackets on the top.
Lift the brackets up and remove the side plates. If the stove
has a smoke outlet on the top, the top plate can be raised and
turned to make it easier to get at the screws
(A)
.
2. If necessary, insert new sides as described in
Chapter 4.4
.
Cast iron and soapstone side panels
1. Remove
the
screws
(Fig. 6 A)
that are underneath holding the
sides in place at the bottom.
2. Loosen
the
screws
(Fig. 19 A)
holding the sides on the top.
Lift off the sides. If the stove has a smoke outlet on the top,
the top plate can be raised and turned to make it easier to
get at the screws
(A)
.
3. If necessary, insert new sides as described in
Chapter 4.4
.
6.3 Replacing the weights
1. Close
the
door.
2. Remove the side plates as described in the previous section.
3. Hold up the weights while loosening the screws
(Fig. 13 A)
and lift the weights off.
4. NB!
The weights are heavy and must be held firmly during
this procedure.
5. When refitting, follow the procedure as described in
Chapter
4.2 “Mounting the weights”
.
6.4 Replacing glass and gaskets in the
door
Fig. 30 - I
1. Remove the side plates as described in
Chapter 6.2.
2. Remove the weights as described in
Chapter 6.3
.
3. Unscrew the wire guides
(Fig. 30 - I, A)
on each side of the
stove.
Fig. 30 - II
4. Open
the
handle
(Fig. 30 - II, B)
but do not raise the door.
5. Remove the four screws
(Fig. 30 - II, C)
and the washers holding
the door in place in the bearing holder.
NB: Ask someone to
hold the door while doing this so that it does not fall down.
Remove the door and lay it, with its outside facing down, on
a soft, clean blanket or mat.
ENGLISH
Summary of Contents for F 471
Page 117: ...117 ...
Page 118: ...118 ...
