23
130112_Rev 2 GF 160 DV 2/22
Installation
Carefully unpack and inspect the contents. Immediately
report any damage to your Jøtul authorized dealer.
DO NOT INSTALL DAMAGED COMPONENTS.
Contents:
1 Adaptor Plate
2 Rear Log
3 Center Log
4 Front Log
5 Left Vertical Log
6 Right Vertical Log
7 Ember Stones, 4 oz.
Tools Required:
• safety gloves
• safety goggles
1
.
Refer to the Contents list and lay out the logs
to identify the parts as shown. The logs engage
with steel pins on the Adaptor Plate (1). Identify
pin engagement holes in the underside of logs 2,
3, and 4. Engagement holes are in the lower ends
of logs 5 and 6.
LOG IDENTIFICATION
1
2
3
4
5
6
A
B
C
C
D
E
PIN IDENTIFICATION
A
2
.
Install the Adaptor Plate (#1) on the burner by engaging
it with the two burner pins (A) at the arrows shown
above.
3
.
Loosely spread a layer of ember stones around the
perimeter of the burner plate.
3
2
4
4
.
Engage the holes in the bottom of Rear Log (#2) with
the two steel pins (B) at the left rear corner of the
burner plate.
5
.
Engage the two holes in the bottom of the Center Log
(#3) with the two burner plate pins (C).
6
.
Engage the holes in the Front Log (#4) with the two
pins (D) in the right front corner.
CAUTION !
Ceramic fiber log surfaces are tender
and can be easilly chipped or scratched.
USE GLOVES AND HANDLE THE LOGS WITH CARE.
Beach Fire Logset 158229
Installation
Instructions