30
139467_03 GF 370 DV II June 2015
Battery Replacement
Battery life depends on many variables; the quality
of the batteries, frequency of remote use, and mode
of pilot operation. Keep a supply of good quality
batteries on hand to be assured of functional
continuity in the event of a power failure.
Figure 61.
156835
Front Glass
Replacement
Kit includes
gasket and spare
retainer clips.
Figure 62 . Accent Lamp Replacement.
Accent Lamp Replacement
Handle the replacement bulb with gloves. Skin oils
will cause the bulb to fail prematurely.
1. Remove the glass frame. See fig. 18.
2. Remove the two retainer screws with a short
phillips screwdriver. Pull the socket out of the
housing.
3. Plug the new bulb into the socket and re-install
the assembly into the lamp housing
.
4. Replace the glass frame using the 4 mm hex key
and socket head screws previously removed.
WARNING!
ALWAYS SHUT OFF THE GAS SUPPLY AND
DISCONNECT THE POWER CORD FROM HOUSE
CURRENT BEFORE REPLACING BATTERIES.
Initializing the Remote Control
Each time you replace the batteries, you will need to
initialize communication between the Receiver and
the Transmitter.
1. Place the slider switch in the REMOTE position.
2. Insert the end of a paper clip into the hole marked
PRG on the Receiver cover. The Receiver will “beep”
three (3) times to indicate that it is ready to syn-
chronize with the Transmitter.
3. Install 3 AAA batteries in the Transmitter bay and
push the ON button. The Receiver will “beep” four
times to indicate the Transmitter’s command is
accepted and sets to the particular code of that
Transmitter. The system is now initialized.
PN 222943 Bulb, 130V / 50W
IFC Battery Replacement
A red LED on the IFC board indicates low battery
power.
1. Switch the Burner to OFF and disconnect power
to the stove.
2. Access the battery box fromthe left side of the
control compartment. It is directly behind the
control switch plate. See fig. 64, #27. Disengage
the box from the hook & loop tape and pull it
out of the compartment.
3. Slide the cover back, install four, 1.5v AA
batteries and replace the box, tucking the wire
leads within the compartment.
4. Reconnect power to the stove.
5. Re-initialize the Remote Control transmitter
following the instructions on page 24.
