6
139775_R
03
_GI 535 DV IPI June 2016
Electrical Hazards
Be aware of electrical wiring locations
when cutting holes in walls and
ceilings for termination.
The blower must be electrically
grounded in accordance with local
codes or, in the absence of local
codes, with the current ANSI/NFPA 70,
National Electrical Code or CSA C22.1-
Canadian Electrical Code.
The blower is supplied with a three-
prong (grounding) plug for protection
against shock hazard and should
be plugged directly into a properly
grounded three-prong receptacle.
DO NOT CUT OR REMOVE THE
GROUNDING PRONG FROM THE PLUG.
Always disconnect the power supply
when performing any service on
the fireplace, including battery
replacement.
4.0 Safety Information
Due to the high operating temperatures this appliance
should be located out of traffic and away from
furniture, draperies, etc. Maintain proper clearance to
combustible mantels and fireplace trim.
Children and adults should be alerted to the hazards
of high surface temperatures and should stay away to
avoid burns or clothing ignition.
Young children should be supervised while they are
in the same room as the appliance. Toddlers, young
children and others may be susceptible to accidental
contact burns. A physical barrier, such as a child
guard, is recommended to be used if there are at-risk
individuals in the house. To restrict access to a fireplace
or stove, install an adjustable safety gate to keep
toddlers, young children and other at-risk individuals
out of the room and away from hot surfaces.
A safety barrier is provided with this appliance
designed to reduce the risk of burns from the hot
viewing glass and shall be installed for the protection
of children and other at-risk individuals.
If the barrier becomes damaged, the barrier shall
be replaced only with the Jøtul barrier part number
225731
.
Any safety screen, glass panel, guard, or barrier
removed for servicing an appliance must be replaced
prior to operating the appliance.
Clothing or other flammable materials should not be
placed on or near the fireplace.
Never allow anyone to use the fireplace if they are
unfamiliar with its operation.
NEVER store or use gasoline or any other flammable
vapors or liquids in the vicinity of the fireplace.
Never burn any solid materials (wood, cardboard,
paper, coal, etc.) in this gas fireplace. Use with natural
gas or propane fuel ONLY.
Do not slam or strike the glass panel.
This appliance is NOT for use with aftermarket glass
doors. This appliance is approved for use only with the
surround panel options listed on page 4 of this manual.
Wear gloves and safety glasses while installing or
performing maintenance procedures on this appliance.
This fireplace insert is specifically designed for use with
3” diameter Listed flexible gas liners.
Power Requirement
This appliance requires 120 VAC power to operate the
blower, accent lamp, and electronic ignition.
Four, AA batteries provide back-up power to
operate the burner in case of a power outage. The
blower and accent lamp will not function with loss of
power.
