Collector Assembly
Mounting parallel bench srew mountingsystem
16
13a )
13b )
14 )
13: Hang the first collector in the lower mounting rail and adjust
(13a + 13b!)
Note:
Distance between collector and end of mounting
rails = 45mm. Measurement A = Measurement B!
14: Place the clamping piece on the upper mounting rail and hand
tighten for now
Sequence: upper mounting rail - hammer-head bolt - washer -
clamping piece - washer - nut
General Note: Before mounting another collector, the cutting ring sc-
rew connection must first be moved onto the connection!
After profiles have been installed on roof
or flat roof frame the collectors need to be
mounted and fixed to same. The bottom
profile rail clips into bottom profile sec-
tion of on-roof collector. The top profile
sits underneath collector as shown. It is
important that the top profile is not fixed
with lip facing up as it does not clip into
collector.
Mounting parallel bench srew mountingsystem
17
15 a )
15 b )
16 )
17 )
15: Attach the second collector (measurement A = measurement B as
shown in Figure 13b).
Please use the mounting jig (15b).
16: Rotate the clamping piece by 90° (see figure 14) and screw it tight
using a long socket wrench
17: With clashing mounting rails, insert and position the mounting part
in the upper mounting rail
Mounting parallel bench srew mountingsystem
16
13a )
13b )
14 )
13: Hang the first collector in the lower mounting rail and adjust
(13a + 13b!)
Note:
Distance between collector and end of mounting
rails = 45mm. Measurement A = Measurement B!
14: Place the clamping piece on the upper mounting rail and hand
tighten for now
Sequence: upper mounting rail - hammer-head bolt - washer -
clamping piece - washer - nut
General Note: Before mounting another collector, the cutting ring sc-
rew connection must first be moved onto the connection!
When fixing the top mid-section(s) slide
bolt into profile as shown.
Fix chamfered plate to profile using this
bolt.
Mounting parallel bench srew mountingsystem
17
15 a )
15 b )
16 )
17 )
15: Attach the second collector (measurement A = measurement B as
shown in Figure 13b).
Please use the mounting jig (15b).
16: Rotate the clamping piece by 90° (see figure 14) and screw it tight
using a long socket wrench
17: With clashing mounting rails, insert and position the mounting part
in the upper mounting rail
Rotate chamfer plate from vertical to hor-
izontal position. As it turns it will clamp
into side profile of each panel. This must
be carried out for each additional panel in
system.
18
