7
QUICK SET-UP
Journey Toilet Lift
Any questions? Call 1-800-958-8324
STEP 6
Install Your Lift On Your Toilet
1. Place your lift over your toilet.
2. Check the adjustment of your lift’s feet. Your lift should be secure, level, and
should not be resting on your toilet. It should be supported on its own.
3. Position the toilet brackets so that the expansion bolts will fit through the holes
on your toilet. These holes are the same holes that your toilet seat mounted to.
4. Put the bolt portion of the expansion bolt through the bracket and the the hole
of your toilet, then position the rubber part of the expansion bolt under the toilet.
Tighten the expansion bolts until they pull the rubber piece snug.
5. Tighten the bracket bolt that secures the bracket to the “rear support”.
6. Test the lift. It should operate smoothly and securely.
7. It should be attached to your toilet so that it will not shift position.
8. When lowered, the lower lip of the lift should be below the rim of your toilet to
prevent spills.
STEP 7
To Plug-In or Not Plug-In
Your Journey Toilet Lift will work plugged-in or solely upon the battery. Using just the
battery, it will provide over 100 lifts on a single charge.
The indicator on the front of the lift provides the status of your battery. Recharge it
when it becomes low. (see step 5).
If you have a GFI-protected outlet near your lift you can plug the lift in full time. Leave
the battery in the lift and plug the charger/power supply (E) into the back of the lift.
This will provide unlimited lifts as well as battery back-up if there is a blackout.
Warning:
Your Journey Toilet Lift requires
a GFCI-protected outlet. Be sure to
only plug it into an outlet that is GFCI
protected. Mixing water and electricity is
dangerous, plug your lift in safely.
