JOUlink AED
JOUlink AED
03
04
Product Description
1
1.1
Intended Use
1.2
Operational Requirement
1.3
Reference ID
The JOUlink data collector automatically monitors and uploads AED
data such as device status, self-test results and location information
to facilitate remote AED maintenance and emergency treatment.
This product can upload information regarding the real-time status
and location of an activated AED, and record events and sounds
throughout AED operation. It enables the tracing and real-time
remote monitoring of AEDs and thus improves the efficiency of first
aid.
JOUlink should be used with the iAED-S1 from within the carrying case
exclusively designed for Jousing products.
The reference ID of the device is ICONNECTOR-C1.
Structural Components
2
2.2
Product Appearance
2.1
Product Componentsnents
The JOUlink product includes the main unit and the battery
pack as shown in Figure 2-1.
Battery Pack: Non-rechargeable
battery (REF: BAT10631)
Figure 2-1 Product Components
The buttons, indicators and markings on the
exterior of the main unit are shown in Figure 2-2
and Table 2-1.
Front
Back
Figure 2-2 Exterior of the Main Unit
2
Name
NO.
Function
Detector Switch
Detect if the device is on or off.
1
Audio Transmission
Outlet
Transmit sound of microphone and buzzer.
Optical Transmission
Outlet
Detect if the device is on or off using a light sensor.
3
Activation Button
Press the button for 1 second when the device is in standby
mode to start connection and activate the device.
4
Status Indicator
Indicate the status of an active device.
A green indicator implies the device is ready for use while a
red indicator implies the device has detected an abnormality.
5
Low Battery Indicator
Indicate the battery remaining of an active device.
If the battery remaining is sufficient, the indicator remains
off. If the battery remaining is low, the indicator switches red.
6
Internet Connection
Indicator
Indicate the network connection status.
If the device is not connected, the indicator remains off. If
the device is connected or in communication, the indicator
will continuously flash.
7
AED Link Indicator
Indicate connection status to the AED Bluetooth.
If the device is not connected, the indicator remains off. If
the device is connected, the indicator will remain lit.
8
Battery Cover
Seal the battery compartment. Open to replace the battery
or SD card.
9
Label
Indicate the name, REF, ID and other information about the
device.
10
Table 2-1 Description of the Exterior of the Main Unit
Main Unit
