18
4)
o
Repeat steps 2 and 3 for the other pole making sure the poles stay vertical. The
PVC poles will flex and show some bending, but that is okay. Make sure that the guy
ropes are secure enough that the wire antenna is roughly horizontal (not too much
sagging). Do not tighten the guy wires too tight because this will cause undue stress
on the dipole antenna.
5)
o
At a North-South distance of 20 ft. (7.6 m) from the first dipole, repeat steps 2-4
and set up the other half of the antenna. Make sure both antennas are parallel and are
roughly facing in the EAST-WEST direction (See Figure 9).
Figure 9a and 9b. Lay out each dipole on the ground. Set up one pole at a time.
Figure 9c and 9d. Set up the remainder of poles.
Summary of Contents for RJ1.1
