Ausgabe 19.05.2017
Copyright by Joy-IT
4
2. PIN Assignment
Note:
Remove the Jumper at position 3 if your power supply is above 12V.
This activates the power supply for the on-board 5V regulator.
The 5V output is perfect for supplying power to an Arduino.
This output is only active, if the jumper on position 3 is set.
PIN
Belegung
1
DC Motor 1 / Stepper Motor +
2
DC Motor 1 / Stepper Motor GND
3
12V Jumper
4
Power
5
Power Supply GND
6
5V Output (if Jumper 3 is in place)
7
DC Motor 1 Jumper
8
Input 1
9
Input 2
10
Input 3
11
Input 4
12
DC Motor 2 Jumper
13
DC Motor 2 / Stepper Motor +
14
DC Motor 2 / Stepper Motor GND
