Ⅹ
COMMON FAULT AND THE PROCESSING METHOD
Fault Symptom
Possible Causes
Solution
Either turning on or turning
off the switch power, the
treadmill can not display
when we the electric power
is connected.
1. The attaching plug is
not inserted well. 2 .The
electrical head‟s
attaching plug is not
inserted well. 3. The
tube fuse is destroyed.
1. Insert it again. 2.
Connect it once
more. 3. Change the
tube fuse.
All the display windows
flicker.
The safety switch is not
settled well or damaged.
Put the safety switch
on the correct place
or mend it.
It stops by itself when it is
working. And all the
displays are normal.
The automatic system
protection.
1. Press the „STOP‟
key, then start it. 2
.Turn off the power
switch, and start it in
one minute.
The running belt can not
work normally, and it has
buzz, with displaying
normally.
The enter voltage is too
low.
Use it when the
voltage return to
normal.
It is regular when it is
running by itself ,and
disordered when someone
walking on it.
Check whether the
running belt is too loose.
Please adjust the
running belt
according to the right
method.
It can not display normally
or can not display.
The electrical head can
not work because of the
external disturbance .
Turn off the power
switch, then turn on
it in one minute.
Because of some reasons, the technical parameter may has a little difference. So we
can not take it as criterion to measure our state of health, all the data is just as a
reference.
Please cut off the power immediately and contact with our agents when there is
special fault symptom. We will provide you the best service in time.
Summary of Contents for Life Fit
Page 1: ...HANDLEIDING Joy Sport Life Fit...
Page 18: ...HANDLEIDING Joy Sport Life Fit...
