18
19
FILLING THE AMPOULE WITH MEDICINE
Remove the cover from the nebuliser compartment by turning it anti-
clockwise until it is released, as shown in the diagram. Pour the medicine
directly into the ampoule and replace the cover on the nebuliser
compartment by turning it clockwise until it is locked.
N.B.: Do not exceed the capacity limit of 12 ml of medicine in the
ampoule. Use only medicines prescribed by your doctor.
CONNECTING THE ACCESSORIES
AND REGULATING THE NEBULISATION
Connect the inhaler tube to the device and then connect to the tube
whichever accessory is to be used (adult mask, children’s mask, mouth
piece, nose piece). Connect to the electricity mains and turn on the device
using the control knob. The indicator light will come on.
Regulate the nebulisation by moving the regulator knob between MIN and
MAX until the required rate is reached. Airflow may be regulated using the
regulator knob located on the side of the device.
When the treatment is finished, turn off the device by moving the control
knob to the OFF position, disconnect it from the electricity mains, remove
any remaining medicine from the ampoule and empty the water tank.
MEDICINE AMPOULE
To clean or replace the medicine ampoule, the lower part of the nebuliser
compartment should be unscrewed as shown in the diagram, then the seal
should be removed and finally the medicine ampoule.
After cleaning or replacement, completely re-assemble the device.
