4-1. Logon Web
IP Phone Web Configuration Menu can be accessed by URL: http://Phone-IP-Address.
Default LAN IP address is “192.168.10.1” while WAN IP address is DHCP.
If web login port of the phone is configured as non-80 standard port, you need to input http://xxx.xxx.xxx.xxx:yyyy, otherwise the web will
show that no server has been found.
Input above IP address and Logon Menu would pop up. Two logon modes as below
-Logon as Guest Account
Default user name and password is guest. You could only have a browse of system with this account
-Logon as Administrator Account
Default user name and password is admin. You could configure your phone with this account
In this guide, only Logon as Administrator Account would be introduced
4-2. VoIP Settings
After you logon in successfully, web would show as below
Choose VOIP on the left column to make VOIP configuration.
-SIP Line Select: Choose SIP 1 or SIP 2, click Load to load corresponding SIP settings
-Register Status: Indicate current registration status of the chosen SIP
-Server Name: Input your server name
You could leave the server name. If you choose to configure it, make it different between two SIPs.
Otherwise, one SIP would not be able to register and show time out.
-Server Address: Configure SIP register server IP address or Domain Name
-Server Port: Configure SIP register server signal port
-Account Name/Password/Phone Number: Configure Account Name/Password/Phone Number
-Enable Register: Choose to enable settings
-Apply: Click to apply above settings
5. Reset Your Phone
To reset your phone
Power off. Long press # until power on. LCD would show POST MODE. Press *#168, LCD would display Conf Reset
5.Plug out power supply, then plug in again to accomplish reset
After above procedures, the phone settings would turn back to factory default
