The DualKlonz is a two-channel amplifier. Switching between channels can be
operated via the Channel switch on the front panel, or via the footswitch.
Modern Channel:
This channel is optimized for High Gain tones. The gain is controlled by the G1
and G2 knobs. These are part of two cascaded preamp stages. The output of G1
stage goes to the input of the G2 Stage. Think of it as a boost pedal (G1) going
into the input (G2) of an amp.
The selection of different Modern models is done through the app or MIDI control
(Please refer to the help file embedded into the app for full features and details.)
This second G2 stage is also bypassed when selecting low-gain models from the
app or MIDI control. In this case the LOW GAIN footswitch won
’
t be active.
Adjust the Bass, Mid, and Treble controls to taste. Adjust the Vo: Master Volume
control for Modern Preamp for the required output level.
10
9
35
36
37
38
39
40
41
42
Typical setup and Cable Connections
Connect a speaker cab to Speaker outputs, following the Cab
’
s specified
impedance. If only one cab is used, always connect it to the “A” outputs. Only If
a second cab is used, connect it to the “B” outputs. If you use two cabs, a
footswitch must be connected to the CAB SW input. If no footswitch is connected,
only the “A” output will be active.
(
IMPORTANT NOTE:
When you are using different types of power tubes, the
output impedances may change. Please pay attention to the back panel to find
out which output to use.)
If used, connect your effects input to the Send output Jack, and the effects output
to the Return input Jack. If necessary, adjust the Level control to adapt the Send
output level to the effects input sensitivity. Typical setting is to adjust the Level
control to STANDARD.
If you use two cabs, a footswitch must be connected to the CAB SW input. If no
footswitch is connected, only the “A” output will be active. When connecting
the footswitch, please put the Cabinet switch plug with “CAB” mark in the
Channel switch Jack, and Channel switch plug with “CHA” mark in the Channel
footswitch Jack, then the Channel switch of the front panel is excluded.
Please make sure that Mains Voltage Selector for 110-120V and 220V-240V input
AC matches your local mains voltage. Check that both On/Off and STANDBY
switches on the amplifier right side are both in OFF position, connect the mains
cable. Turn on the Power switch. Allow at least 2 minutes for the tubes to warm up.
Connect your instrument to the guitar input jack on amplifier left side, and turn
down the Vo: Master Volume control for Modern Preamp and Vo: Master Volume
control for Vintage Preamp to the minimum. Turn on the STANDBY switch and
complete cable connections.
1.
2.
3.
4.
Amplifier Operation
F o o t s w i t c h
Channel switch indicator
: when the Channel switch indicator is ON, it means
the Modern channel is active, when the indicator is OFF, the Vintage channel is
active.
Channel footswitch
Cabinet switch indicator
: when the Cabinet switch indicator is ON, it means
the “A” output cab is active, when the indicator is OFF, the “B” output cab is
active.
Cabinet footswitch
LOW GAIN indicator
: when in Modern channel and the amps with LOW GAIN
function, if the LOW GAIN indicator is ON, it means the LOW GAIN is active, if
it’s OFF, then not active. (In Vintage channel, LOW GAIN is not active)
LOW GAIN footswitch
Channel switch plug
Cabinet switch plug
35.
36.
37.
38.
39.
40.
41.
42.
Typical setup and Cable Connections
Amplifier Operation
Footswitch
Typical setup and Cable Connections
