Five-year warranty
Contact us for complete terms
and conditions.
Joyolight reserves the rights change our products and specifications
at anytime without prior notice and such modification shall be effective
immediately. Contact Joyolight for the latest product information.
JOYOLIGHT GROUP INC.
#12, 5200 Dixie road
Mississauga, ON, L4W 1E4
sales@joyolight.com
1-877-849-1942 (US)
647-496-8107 (CA)
INS 2022-05
CON-WH-1Z
Code Clearing
Connecting the load to the
receiver and power on it.
1. The clearing operation
should be finished within 1
minutes after the receiver is
powered on.
2. Batch operation can be
performed within the remote
control range.
Press and hold “ON/
OFF“ key for
20s
until
the indicator of remote
control process the state
as 100%-off-100%.
Press and hold “
DIY 2
“ on the
remote control for
5 sec
.
1. Once the indicator of the
remote control flashed quickly,
and the load light flashed 3 times
and returned to the initial state,
it enters the clearing code trans-
mission status.
2. If the original remote control is
lost, the new remote control can
be used for clearing operation.
Press “
DIY 2
“ to submit
and finish the operation.
The indicator of the remote
control will flash 3 times after
successful operation
Press any key to exit
and end the operation.
It will automatically exit code
transmission status after 60 sec.
The original code value of the receiver needs to be cleared before learning a new code.
Restoring factory settings of remote control
Used to unify system code values or copy a new
remote controls. Each remote controller has its own unique
code at the time of delivery. When there are multiple remote
controllers in a system, one of them must be selected as
a main. The others should copy its RF code.
Code learning operation
between remote controls:
Turn off the power sup-
ply of the controllers.
Press and hold “
ON/OFF
“
for
5 sec
until indicator of
remote control turns off
Once the indicator of the
remote control flashed quickly,
and the load light flashed 3
times and returned to the ini-
tial state, it enters the pairing
code transmission status.
Turn on the power supply of
the controllers. Its indicator
will flash 3 times after suc
-
cessful code leaning
It will automatically exit code
transmission status after 60 sec.
1.
Main
Remote Control: Press and hold “
DIY 1
“ for 5 sec. Remote
control enters the pairing code transmission status when its indicator
flashes quickly.
2.
New
remote control: Press and hold “
ON/OFF
“ for 5 sec. The re-
mote control enters learning status when its indicator turn from 100%
to off.
3.
The indicator of the new remote control will flash 3 times after
successful code learning.
Remote Control RF code
learning from controllers
