Adjustment and operation
Remote control operation
Remote control is single button mode, one same button on the remote control to circularly control
the main engine OPEN/STOP/CLOSE/STOP.
A
B
C
D
CLOSE
CLOSE
OPEN
OPEN
STOP
STOP
Pedestrian
Pedestrian mode
mode
Figure 24
Add extra remote control (remote control learning):
Remove the upper cover of main engine;
press the learning button S1 on the control board, and indicator light LEARN will flash once and then
go out; press the same button on the remote control twice, the LEARN flashes repeatedly and then
goes out; remote control learning is succeed. At most 25 remote controls can be learned.
Delete remote control:
Delete remote control that have been learned; press the learning button
S1 and LEARN will be on; loosen the button until LEARN is off. This indicates that all remote
controls that learned previously have been deleted.
The fourth button on the remote control is for pedestrian mode, press the button the door will open
about 1 meter when the door is closed, for pedestrian only.
Note
: To disengage gate opener, move the gate to the middle position, then close the clutch and
press the open button of external button switch to open the gate.
If the gate opening direction is
wrong, exchange the two motor lines MOT2 and MOT1. Please seriously observe whether the
motor can stop automatically when the gate fully opened. If the position cannot be limited
correctly, please exchange limit switch lines 11 and 13.
5. Others
5.1 Maintenance
Check whether the gate operates normally every month.
For the sake of safety, each gate is suggested to be equipped with infrared protector, and regular
inspection is required.
Before installation and operation of the gate opener, please read all instructions carefully.
Our company has the right to change the instruction without prior notice.
