SL600AC SLIDING GATE OPERATOR
18
z
Three-button mode external button switch (not supply):
press ‘OPEN’ button, the gate opens. Press ‘STOP’ button, the
gate stops. Press ‘CLOSE’ button, the gate closes.
z
Single-button mode external button switch / keypad (not
supply):
With each press of the button, the gate will close, stop,
open or stop cycle.
z
Auto-close function:
This feature can be selected to make the
gate stay open for some seconds before it automatically closes.
The auto-close time can be adjusted to between 12, 24 and 36
seconds.
z
Safe guard (Infrared photocell):
If infrared beam is interrupted
during closing, the gate will reverse and go open immediately.
This feature will not function if the gate is in fully opened and
closed positions or during opening.
z
Open priority:
The gate will return to open if press ‘OPEN’
button of external button switch during closing.
z
Limit switch:
The switch is used to accurately stop the gate in
the opened and closed positions.
If the gate stops at opened position when the limit switch is
reached, the gate will not move if you press ‘OPEN’ button.
If the gate stops at closed position when the limit switch is
reached, the gate will not move if you press ‘CLOSE’ button.
z
The device is installed with a thermal protector, the thermal
protector will switch off the motor automatically in case of the
temperature is higher than 120°C and switch on the motor
automatically when the temperature is lower than 85°C
±
5 °C.
9. LED
indicate
a. LED of Power indicated the input power.
b. LED of LEARN indicated the transmitter learn status.
c. LED 1 indicate the ‘CLOSE’ external button, if the button is
SL600AC SLIDING GATE OPERATOR
19
pressed the LED will light.
d. LED 2 indicate the ‘OPEN’ external button, if the button is
pressed the LED will light.
e. LED 3 indicate the ‘STOP’ external button, if the button is
pressed the LED will light.
f. LED 5 indicate the ‘O/S/C’ external button, if the button is
pressed the LED will light.
g. LED 6 indicate the ‘pedestrian switch’ external button, if the
button is pressed the LED will light.
h. LED 7 indicate the ‘infrared sensor’ status, if the output is
connected the LED will light.
i. LED 9 indicate the ‘Loop detector’ status, if the output is
connected the LED will light.
j. LED 10 indicate the ‘Close limit switch’ status, if the switch is
connected the LED will light.
k. LED 12 indicate the ‘Open limit switch’ status, if the switch is
connected the LED will light.
All these LED position see the Fig.8
10. Maintenance
z
Check the door once a month. The door should be carefully
checked for balance. The door must be in good working order.
z
We suggest for safety reasons, photocells be used on all gates.
z
Disconnect from mains supply before replacing bulb.
z
Be sure to read the entire manual before attempting to perform
any installation or service to the door operator.
z
Our company reserves the right to change the design and
specification without prior notification.
