SL600AC SLIDING GATE OPERATOR
14
7. Tuning and operation
a.
Adjust the
Adjustable resistance (see Fig.8)
VR1: For motor working total time adjustment.
Clockwise rotation to increase, counter-clockwise rotation to reduce.
The total time can be set to 10 seconds as minimum and 90 second
s as maximum.
VR2: For brake force adjustment in limit position.
Clockwise rotation to increase, counter-clockwise rotation to reduce.
Rotate to minimum to cancel brake function in place.
VR3: For slow stop width adjustment.
Clockwise rotation to increase, counter-clockwise rotation to reduce.
VR4: For motor output force adjustment to keep safe usage.
Clockwise rotation to increase, counter-clockwise rotation to reduce.
Warning:
Motor force can not be set too large, just drive the door is ok.
Remote control
z
The remote control works in a single channel mode. It has four
buttons. See Fig.12 Remote transmitter. The function of button
1, button 2
、
button3 are the same and button 4 is pedestrian
mode. With each press of the remote control button (1, 2 and 3)
which has been programmed, the gate will close, stop, open or
stop cycle.
SL600AC SLIDING GATE OPERATOR
15
Remote Pedestrian button: After you learn the transmitter, you
press the remote button 4 the door will open 1 meter when the
door is closed.
z
You can program/learn button 1, button 2, and button 3
individually. If you learn button1, the button 1 and button 4 are
enable, if you learn button 2 too, the button 2 and button 4 are
enable, the button 1 is disable.
Button 1
Button 2
Button 3
Button 4
Fig.12
Remote transmitter
z
Adding extra remote controls (Learn):
Remove the cover, press
and hold the learn button ‘S1’ (Fig.8) more than 2 seconds, then
the ‘LED of LEARN’ (Fig.8) will be on, then press the remote
control button which you want to use, the ‘LED’ will turn on about
2 seconds and then turn off again. The learning process is
finished.
Up to 25 remote controls may be used.
z
Erase remote controls: To erase all existing remote controls,
press and hold learn button ‘S1’, the LED of ‘LEARN’ will turns
on, release the button until the LED turns off. This indicates
that all the remote controls have been erased completely, if you
change another manufactory code transmitter must erase first.
z
Verify open direction: If the gate does not move in the desired
direction, then you will need to reverse the motor operating
direction, open the black plastic cover, you can do this by
exchanging wires ‘MOT1’ and ‘MOT2’, ‘Open limit(13 of J5)’ and
‘Close limit(11 of J5)’.
