3. JR XP652 Systems
The following activation and set-up procedure should be used for
all JR XP652 systems. Please note that the XF622 and XP642
6-channel systems do not have the required CCPM software, and
therefore cannot be activated by the Horizon service center.
Prior to activating the CCPM function, it is first suggested that the
Data Reset function be performed to reset the desired model
number to be used back to the factory default settings.
Caution: Prior to performing the Data Reset function, it will be
necessary to select the desired model number to be used.
A) Press the Mode and Channel Keys simultaneously while
turning the power switch on to enter the system mode.
Next, press the Channel key until “MDL” (Model Select)
appears on the screen and choose the desired model
number to be used.
B) Press the Mode key until “RST” (Data Reset) appears on
the screen. Press the + and - keys simultaneously to
reset the current model. A high pitched beep will indicate
that the reset was successful. Press the Mode and
Channel keys simultaneously to exit the system mode.
C) With the power switch still on, press the Mode and
Channel keys simultaneously to enter the function mode.
Press the Mode key until “MIX CCP” (CCPM mixing)
appears on the screen. Press the + or - keys to activate
the CCPM function. “MIX CP2” should appear on the
screen. Next, press the Channel key until “MIX CP6”
appears on the screen. It will be necessary to change
the value of CP6 (Channel 6, Aux1) from +60 to -50
using the - key.
D) Press the Mode key until the servo reversing screen
appears on the screen. Next, reverse the Throttle (THR),
Aileron (AIL) and Rudder (RUD) channels by pressing the
Channel key to select the desired channel, and then the + or
- keys to set the servo direction.
E)
Press the Mode key until “TRV ADJ” (travel Adjust)
appears on the screen, and adjust the travel values as
shown by pressing the Channel key to select the desired
channel, and then the + or - key to set the desired travel
value. Press the Mode and Channel keys simultaneously,
or turn the power switch off, to exit the function mode.
Please note that the throttle travel values may vary based
upon the type of engine used. This value can be fine
tuned once the throttle linkage has been installed.
CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT, continued
mdl
1
Indicates Model Select
Indicates current model
rst
he
Indicates Data Reset
Indicates Model Type
mix
CCP
of
Indicates CCPM Mixing
Indicates inhibited
thro
trv adj
-130
ail
-120
ele
-120
rud
-150
pit
-120
ail
rev.norm
rud
rev.norm
Indicates
Channel
Indicates
Reversed
Indicates
Channel
Indicates
Reversed
thro
trv adj
-110
ail
-100
ele
-100
rud
-150
pit
-100
Ch
Ch
Ch
Ch
Ch
Ch
Ch
Ch
Digital Servos, Super Servos
Standard Servos
48
mix
CP6
— 50
%
Indicates Channel 6 (Aux 1, Right Servos)
Indicates value set – 50%
Note: The travel values shown for the rudder function are for use with Piezo gyros, like the JR NEJ-900, NEJ-400,
NEJ-450, or NEJ-3000 type gyros. If a conventional mechanical type gyro is used (JR 120, 130, etc.), then the
travel values of the rudder will need to be reduced to approximately 100%.
JRP9012.46 Robinson R22 Manual 10/6/00 5:06 PM Page 48
