60
H) Throttle Hold Setting
Press the UP key to select the THRO HOLD function. Press the INCREASE key to activate the function.
Once the throttle linkage is set up, set the hold position in this function so that when the throttle hold
switch is pulled, the throttle servo does not move with the throttle stick at idle and throttle trim set at
the idle position.
I) Gyro Sensitivity Selection
Press the UP key to select the GYRO SENS function. Set the gyro gain as shown as a starting point for the G770 3D
gyro. Adjust the percentage as necessary when flying the heli. Other gyros may require different settings; consult
your gyro manual for further information on setting the gain.
Summary of Contents for Vibe 90SG
Page 77: ...77 ...
Page 105: ...105 ...