The following activation and setup procedure should be used for the Spektrum DX6i systems. Prior to
activating the CCPM function, it is first suggested that the data reset function be performed to reset the
desired model number to be used back to the factory default settings.
Caution
: Prior to performing the data reset function, it will be necessary to select the desired
model number to be used.
A) Model Select/Data Reset
Turn the power switch on then press the roll selector to enter the Adjust List. Next, move the cursor to
the MODEL SEL function. Press the roll selector to enter the model select function. Select the desired
model number to be used, then press the roll selector. Move the roll selector to highlight SET UP LIST
and press the roll selector. Then move the roll selector to highlight COPY / RESET, then press the roll
selector. Move the roll selector to highlight RESET, press the roll selector, then press YES to reset the data
of the current model selected.
B) Servo Reversing
Move the roll selector and highlight REVERSE on the screen, then press the roll selector. Next, reverse
channels 1, 3, 4, and 6 by moving the Roll selector to highlight each channel, pressing the roll selector, then
moving the roll selector to change to R from N as needed. After making each selection, press the roll selector
to confirm the change, then proceed to the next channel. Move the roll selector to highlight LIST and press
the roll selector to exit the function.
SPEKTRUM DX6i SYSTEMS: PROGRAMMING
53
