21
3-3
LANDING GEAR ASSEMBLY INSTALLATION
...4 pcs
..........................4 pcs
............................8 pcs
Socket Head Bolt, 3 x 20 mm
Socket Head Bolt, 3 x 20 mm (4 pcs)
Nylon Lock Nut, 3 mm
Nylon Lock Nut, 3 mm (4 pcs)
Flat Washer, 3 mm
Flat Washer, 3 mm (8 pcs)
.........................4 pcs
Set Screw, 4 x 4 mm
Set Screw, 4 x 4 mm (4 pcs)
Antenna Tube
Landing Skid (2 pcs)
Landing Struts (2 pcs)
Landing Skid Cap
Use CA adhesive
to attach.
TEAM TIP:
The four 3 x 20 mm landing gear bolts can be installed
from the top (opposite diagram) for a cleaner appearance.
TEAM TIP:
The landing skid tubes can be shortened by 3" to save
weight and provide a cleaner apearance. — Len
TEAM TIP:
The landing skid tubes can be shortened by 3"
to save weight.
3-4
COOLING FAN/HUB INSTALLATION
Socket Head Bolt, 3 x 6 mm
Socket Head Bolt, 3 x 6 mm (4 pcs)
..................4 pcs
4 pcs
Nut (supplied with engine)
Washer
(supplied with engine)
Use for O.S. engines
only. Omit for YS
engines.
Taper Collet Upper (small)
Taper Collet Lower
(large)
...........................4 pcs
Flat Washer, 3 mm
Flat Washer, 3 mm (4 pcs)
Cooling Fan
Blades
Cooling Fan Hub
Use Red
Threadlock
*
*
*
*
*
Tighten bolts evenly
to prevent warping.
TEAM TIP:
It is recommended that a
piston locking tool be used to properly
secure the fan assembly to the engine.
When using a piston locking tool, it is
necessary to also hold the fan assembly
to prevent excess loads from being
applied to the piston.
3"
Shorten
(optional)
Red
Summary of Contents for Vigor CS
Page 64: ...64 E A C D G F DECAL PLACEMENT ...
Page 65: ...65 B 3 2 5 1 DECAL PLACEMENT ...