28
4-4
FLYBAR INSTALLATION
4-5
FLYBAR PADDLE ATTACHMENT
Center the flybar in the seesaw
shaft before securing the two
flybar control arms.
Caution:
Check to insure that the two
flybar control arms are parallel
to the center line of the flybar.
Caution:
5 mm
Washer, 4 x 6 x 0.5 mm
Washer,
4 x 6 x 0.5 mm (2 pcs)
Flybar, 610 mm
(Version #1 long)
Set Screw, 4 x 4 mm
Set Screw,
4 x 4 mm (2 pcs)
...............................2 pcs
Nylon Lock Nut, 4 mm
............2 pcs
............................2 pcs
Flybar Control Arm
Flybar, 450 mm
(Version #2 short)
Equal Distance
Equal Distance
Your Vigor
™
CS includes two sets of
flybar paddle combinations, so the cyclic
rate of the model can be adjusted for
the desired “feel” or control response.
Note:
Set Screw, 4 x 4 mm
...................2 pcs
Version #1 only
Nylon Lock Nut, 4 mm (2 pcs)
(For version #1 only)
VERSION #2
Paddle threads onto
450 mm flybar.
VERSION #1
Front Hole:
Recommended for a
moderate to high
cyclic rate.
Rear Hole:
Very agressive cyclic rate.
Not recommended
as the cyclic rate
will be excessive.
450 mm
Flybar
Thread the grey paddle onto the
flybar approximately 25 mm.
Adjust each flybar paddle so they
are parallel to the flybar control
arms and to each other.
Version #2 Note:
Thread each flybar paddle
onto the flybar until the
threaded tip of the flybar
protrudes approximately
5 mm. Adjust each flybar
paddle so they are parallel
to the flybar control arms
and to each other. Secure to
the flybar using two 4 mm
nylon lock nuts. Note proper
direction of each flybar
paddle (short portion
forward, clockwise rotation).
Version #1 Note:
Set Screw,
4 x 4 mm (2 pcs)
Flybar Paddles
(2 pcs) Red, Version #1
Flybar Weight
(2 pcs)
Version #1 Flybar 610mm (long)
Red Control Paddles
This will provide a slow to
moderate cyclic rate. This is ideal
for contest or smooth 3D type flying.
Version #2 Flybar 450mm (short)
Grey Control Paddles
This will provide a moderate to
high cyclic rate. This is ideal for
smooth or agressive 3D type flying.
610 mm Flybar
Align paddles
so they are parallel
to each other.
TEAM TIP:
Use JB-weld (epoxy steel) to
glue the flybar paddles to the flybar. Still
use the nut as well. The glue prevents the
paddles from turning in flight.
TEAM TIP:
Flight tune your Vigor to achieve the desired cyclic rate by moving
the flybar weights in and out on the flybar (in=more cyclic rate, out=less).
Make sure that they are set to the same distance or vibration can occur.
Summary of Contents for Vigor CS
Page 64: ...64 E A C D G F DECAL PLACEMENT ...
Page 65: ...65 B 3 2 5 1 DECAL PLACEMENT ...