32
Socket Head Bolt, 3 x 40 mm (2 pcs)
Tail Boom, 879 mm
Aluminum Tail Boom Holder, Silver
Aluminum Tail Boom Holder, Black
Nylon Lock Nut,
3 mm (4 pcs)
* Do not tighten bolts
until bevel gear mesh
has been adjusted.
Flat Washer,
3 mm (4 pcs)
Before tightening of the 4 tail
boom mounting clamp bolts, it
will be necessary to set the bevel
gear to bevel pinion gear mesh by
raising or lowering the tail boom
assembly.
To set the proper mesh, insert
1 thickness of paper (the same
thickness as the pages of this
manual) between the 2 bevel
gears.
Next, push the tail boom assembly
down so that there is no gear
backlash with the paper in place.
Tighten the 4 tail boom mounting
bolts. Next, remove the thickness
of paper and check the gear
mesh. There should be a very
slight amount of backlash. If the
backlash seems too much, repeat
this procedure using thinner
paper. If backlash can't be
detected, double the paper
thickness and retest.
It is better to set this
gear mesh slightly tight,
rather than loose, or
damage to the bevel
gear can occur during
extreme 3D flying or
tail blade contact with
the ground.
Note:
BEVEL GEAR MESH ADJUSTMENT
*
*
*
*
Socket Head
Bolt, 3 x 8 mm
Rod Guide
Socket Head Bolt, 3 x 40 mm
Nylon Lock Nut, 3 mm
... 2 pcs
.................................. 3 pcs
Must be aligned.
Flat Washer, 3 mm
.................................... 4 pcs
Socket Head Bolt, 3 x 8 mm
........................... 1 pc
Aluminum Tail Boom
Holder, Black
Aluminum Tail Boom Holder, Silver
Bevel Pinion Gear
Assembly
Aluminum Tail Boom Holder, Black
Note proper direction during
installation as bottom hole is
offset to match frame.
5-4
TAIL BOOM/BEVEL PINION GEAR INSTALLATION/ADJUSTMENT
Install the tail boom holders
so the slotted side is toward
the top. Also, it's important
to make sure that the black
tail boom holder is at the
front of the tail boom as
shown.
Note:
Slot
Up
Tail Boom Holder
The 2 3.5 x 6 mm bolts
included in this step are
not used.
Note:
Summary of Contents for Vigor CS
Page 64: ...64 E A C D G F DECAL PLACEMENT ...
Page 65: ...65 B 3 2 5 1 DECAL PLACEMENT ...