PAGE 12
SCENECONTROL 100 OPERATING INSTRUCTIONS
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
www.jrclancy.com
Rev 3: October 7, 2009
ormal operation. If load faults occur during normal operation (false tripping),
ers page and increase the value of the LOAD WNDW parameter.
the user level user name and
ill turn
system preset contains a target for the selected
E
he
by
the move. If the operator cannot see all of the sets throughout their travel, have
system is not too sensitive for n
return to the load sensing paramet
SYSTEM PRESETS PAGE
From the system base screen, the SYSTEM
PRESETS touchbutton opens the system presets
page for the control system. The SYSTEM
PRESETS touchbutton is password-protected; the
operator must enter
password to access the system presets playback
or record functions.
The indicator at the top right corner of the screen
will be green and display the legend ESTOP OK if
the emergency stop system is healthy, or w
red and display the message ESTOP FAULT if an
emergency stop button has been pressed.
The touchbuttons on the left of this screen
correspond to the eight system presets. Each
winches in that preset. To run a system preset, touch the desired preset selection button (SYS P-1 through SYS
P-8). When selected, the system preset comment recorded with that preset will display at the top of the page.
SET PREVIEW touchbutton. This will open the
There is a green indicator next to each winch
that is enabled for this system preset. The
positions of all winches are shown in the
column at the center of the screen, while the
targets for the winches are shown in the next
column. The column at the right indicates t
To see the contents of a system preset, touch the SYSTEM PR
system preset preview page, shown below.
speed for the winches. System presets use
each winch’s default speed when recorded.
To run a system preset, return to the system
preset base page and hold the GO TARGET
button. The speed of the winches may be
varied with the joystick, just as with a single
winch move. You may monitor the actual
positions and speeds of the winches
returning to the system preset preview page
while the move is running. Remember to have a spotter watch the pieces if you are going to watch the screen!
NOTE: A system preset contains a target for multiple winches in the control system. Before running a system
preset, be sure that
all
of the winches in the preset are clear to move. Make sure that the operator can see all of
the sets being operated during
