PAGE 7
SCENECONTROL 100 OPERATING INSTRUCTIONS
WINCH OPERATION- TARGET CONTROL
There are several ways to designate a target for winch operation. First is to enter the target directly. To do this,
touch the TARGET field. A numeric keypad will open: use it to key in a new numeric target. When you touch the
ENTER key on the keypad, the new value will be transferred to the TARGET field, and the keypad will close.
A pre-recorded target may also be loaded into the TARGET field by touching the SUL (Soft Upper Limit), SLL
(Soft Lower Limit), POS AS TRGT (Position as Target) or one of the Preset buttons (P-1 through P-8).
Once a target has been designated, the winch may be run to that target by pushing and holding the GO TARGET
button on the control station. The winch will accelerate to the designated speed and travel until it reaches the
target. If the GO TARGET button is released before the winch reaches the target, the winch will decelerate to a
stop at that point in its travel. The speed of variable-speed winches may be varied by using the joystick, as
described under Direct Control, above. Fixed-speed units will only operate at their designated speed.
RECORDING PRESETS
It is possible to record up to eight presets per winch on the system. A preset consists of a comment, and a target
and a speed. For fixed-speed winches, a preset consists of a comment and target (no speed). To record a
preset, first designate the desired target and speed on the motor base screen, as described in the previous
section. Next, open the Preset Record screen by touching the PRESET RECORD touchbutton on the winch base
screen. Preset recording is a password-protected function. If a password is not currently active, the login screen
will pop up, prompting you to enter a user name and password using the on-screen keyboard.
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
www.jrclancy.com
Rev 3: October 7, 2009
To enter the user name, touch the user name
field; an alphanumeric keypad will appear. Use
this to key in the appropriate user name, then
press the ENTER (<-) key on the keypad.
Follow the same procedure in the password
field to enter the password.
When these have been successfully entered,
verify that the desired target and speed values
are still in place, then touch the PRESET
RECORD button to open the winch preset
record screen.
Once on this page, the preset number is set
to zero, and the legend NOT A VALID
PRESET NMBR appears in the top center of
the screen. Enter a preset number (1-8) by touching the ENTER PRESET NUMBER numeric field. A keypad will
open on the screen; touch the desired number (1-8) and then touch the ENTER key to return to the preset record
screen.
Touchscreen display winch preset record screen
Once the desired preset number has been selected, enter a comment describing the preset by touching the
ENTER PRESET COMMENT data field. An alphanumeric keypad will appear; use it to key in the comment,
followed by the ENTER key. The preset record screen will re-appear.
