©JRI Maxant
10
I.
INTRODUCTION
Congratulations, you own a Mini SPY RF GREEN! This device is equipped with 1 internal sensor. It enables you to record the ambient temperature and to transfer
wirelessly the recorded data by radio frequency to a PC.
a)
Equipment
¾
1 or several Mini SPY
RF
GREEN
¾
1 user manual
b)
Symbols
II.
PRESENTATION
III.
INSTALLATION RECOMMANDATIONS
The Mini SPY RF GREEN is a recorder of physical parameters able to communicate wirelessly with the operating software SIRIUS.
The wireless communicatin is based on radio frequency. As we are daily in contact with it (radio, TV…) it is easy to think that it always works. This true if basic rules on
recorders positioning are respected concerning because wireless communication is subject to perturbations.
a)
Perturbations sources
¾
Presence of obstacles in the way of the waves between the SPY RF ModeM and the Mini SPY RF GREEN (wall, ceiling, person, furniture…) or
close to the antena.
¾
Obstacles thickness in the way of the waves. The absorption is more important in diagonal as perpendicularly
¾
Waves cannot pass through full metallic walls. On the other hand, a perforated wall allows the waves passing with attenuation
RECYCLING : do not throw in a rubbish dump or in a domestic waste container. Comply to the regulation to throw away the
device.
CE MARKING : this equipment is certified to comply with the European regulation for the electric security, inflammability,
disturbing radiation emission and immunity to surrounding electric disturbances.
FCC ID :W45
03330
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation
In accordance with FCC requirements, changes or modifications not expressly approved by JRI Maxant could void the user's
authority to operate this product.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Running led (green)
Push button
Alarm led (red)
T° sensor
Identification label
