©JRI
14
b)
Programmed Start Delay
The SPY IP displays the date/time at which the relevant measuring channel will start
recording.
Caution
: This mode is only valid once. If the recording is stopped the SPY IP will indicate
that it is awaiting configuration.
c)
Push-button
The temperature display screen will show only a push-button for channels being
configured in this mode.
When you press the push-button an identification window will become available.
Enter the identification code. Once approved
by Sirius the relevant measuring channel
will start recording. If the operator does not have the rights, the action will be rejected
and an error message is displayed for a few seconds before the push-button appears
again.
d)
Target value reached:
This type of start mode can only be configured channel by channel. The channel will start
recording when it has reached its target value taking into account the direction of the
variation (upward or downward movement).
If a channel has no target value, it is
considered as being configured in « immediate » start mode.
ou
e)
Dry contact (change of state)
The recording of one channel can be regulated by the change of state of a contact
connected to one of the other channels. The screen of the channel waiting to start
recording will look like one of the following figures:
These figures show that channel 1 will start
recording when channel 2 changes state
(rising or falling edge)
Note: when channel 2 returns to its original
state, channel 1 will stop recording.
2)
Off Modes
All « off modes » are compatible with all « start modes »except for « immediate » start
mode because as soon as the stop has been requested the SPY IP will start recording again.
The programmed « off mode » will appear in the bottom right-hand corner (zone 5)
or Target value Programmed stop delay Push-button
Memory Full
Current
instantaneous value
Target value
Summary of Contents for SPY IP 4
Page 1: ...USER MANUAL SPY IP 10486F...
