©JRI
3
I.
INTRODUCTION
Congratulations, you own a SPY RF AIR ! This device is equipped with a built in temperature and humidity sensor which
enables you to record the temperature and humidity of ambient air and to transfer wirelessly the recorded data by radio
frequency to a PC.
a)
Equipment
1 SPY RF AIR
1 wall-mounting bracket
1 user manual
b)
Symbols
II.
INSTALLATION RECOMMANDATIONS
The Spy RF is a recorder of physical parameters able to communicate wirelessly with the operating software SIRIUS.
The wireless communication is based on radio frequency. As we are daily in contact with it (radio, TV…) it is easy to think
that it always works. These true if basic rules on positioning recorders are respected because wireless communication is
subject to perturbations.
a)
Perturbations sources
Presence of obstacles in the way of the waves between the Spy RF ModeM and the Spy Rf (wall, ceiling,
person, furniture…) or close to the antenna.
Obstacles thickness in the way of the waves. The absorption is more important in diagonal as
perpendicularly
Waves cannot pass through full metallic walls. On the other hand, a perforated wall allows the waves to pass
with attenuation.
RECYCLING : do not throw in a rubbish dump or in a domestic waste container. Comply to the regulation to throw away the device.
CE MARKING :this equipment is certified to comply with the European regulation for the electric security, inflammability, disturbing
radiation emission and immunity to surrounding electric disturbances.
FCC ID :W45 03330
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation
In accordance with FCC requirements, changes or modifications not expressly approved by JRI could void the user's
authority to operate this product.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
