KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
107
IT IS ABSOLUTELY PROHIBITED
to connect uncleaned pipelines and hydraulic cyl-
inders of agricultural machines and implements to the hydraulic system of the tractor;
check the oil level in GB after engagement of the PTO shaft, if necessary, refill it.
Fulfil the following rules of operation for pneumatic tyres:
a) do not permit tractor operation with significant wheel slip;
b) do not permit tractor operation and parking with damaged and blown-out tyres;
c) do not permit travelling on tyres with decreased internal pressure even for small
distances as it leads to tyre failures;
d) in order to avoid increased wear of tyres, operate the tractor on roads with hard
pavement for 30% of the total operation period max;
in case of execution of hauling operations, set the fuel supply lever into the position of
minimum fuel feed;
strictly obey the instructions set forth in the “Safety requirements” section.
CAUTION!
In order to prevent untimely failure of the rear axle cardan gear and to re-
duce the wear of tyres, it is necessary to engage the rear axle only in case of tractor
operation with agricultural implements and during travel in heavy road conditions.
When moving in good road conditions (on roads with compact ground or with pave-
ment), the rear axle shall be disengaged.
6.3 INSTALLATION AND DISMANTLING OF WHEELS WITH TYRES
Tyres shall be operated and stored in accordance with the tyre operation instructions for trac-
tors and agricultural machines.
Mount only serviceable tyres, inner tubes and rims corresponding by
size and type.
Tyres shall be clean, dry. Before installation, tyres and inner tubes shall be poured with talc.
Installation and dismantling of tractor wheels shall be carried out by two workers by means of
two tyre irons.
