KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
18
When turning, select the speed providing for a safe traffic.
IT IS PROHIBITED
to enter tight
turns at a gear exceeding the first gear of the fourth mode.
When crossing dams, dikes and bridges, make sure of the possibility to drive ahead and use
only low gears.
Before passing route portions requiring engagement of both driving axles (ascents, heavy-
going areas), actuate the rear axle beforehand.
When working on slopes, exercise caution, carefulness in tractor driving and meet the follow-
ing conditions:
do not shut off the engine and do not change gears and modes on steep ascents and
descents;
during motion down the slope,
IT IS PROHIBITED
to use coasting;
it is allowed to operate across the slope (slope angle shall not exceed 5°) only in
modes I...II, avoiding sharp turns and not driving over obstacles.
Ford across water obstacles only after a thorough preparation and inspection of the route of
travel. Fording is allowed with the depth of 0.8 m max for K-744R1 tractors and 1.0 m max
for K-744R2, K-744R3, K-744R4 tractors.
Coupling to, and mounting of agricultural machines and implements on the tractor shall be
carried out by persons operating such machines. Coupling worker who mounts a machine
shall sta
y aside until full stop of the tractor and begin coupling (mounting) only after driver’s
signal.
During operation of the tractor with agricultural machines and implements, observe the safety
rules set forth in the operation manual for such machines or implements.
Approach the agricultural machines, implements or trailers on the tractor at the minimum
speed with the drain gate drive pedal being depressed incompletely, having honked in ad-
vance.
Having connected the trailing implements and pumped through the hydraulic system, check
the level of oil in the hydraulic tank and, if necessary, refill it.
IT IS STRICTLY PROHIBITED
to stay under an agricultural implement being lifted.
In case of long-term outage, do not leave the mounted agricultural implement in the lifted po-
sition.
IT IS ABSOLUTELY PROHIBITED
to stay under the implement being lifted.
When working with hydraulic agricultural machines and implements, it is necessar6y to re-
member that the maximum working pressure at the outlet of quick lock rupture devices is at
least 15.0 MPa (150 kgf/cm
2
).