KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
39
perform the assembly under conditions preventing the possibility of ingress of chips,
grit, etc, on the parts being assembled.
surfaces of all rubber parts should be lubricated with a thin layer of grease ZHT-72
ЕГ 38101345-77 (consumption rate is 0.01 – 0.012 g/cm
2
). Replacing material is
grease Agrinol ZHT-72 TU U 26.4
–30802090-058:2006.
when installing rubber parts, prevent the possibility of a damage to them. Cuts,
marks, etc. on the surfaces of rubber parts are not allowed.
Fig. 1 Regeneration holder 8043.35.12.460
1- 8043.35.12.115 cap; 2- 8043.35.12.122 ring; 3- 8043.35.12.121 base;
4- 8043.35.12.139 sleeve; 5- 8043.35.12.141 sleeve cover; 6- 8043.35.12.142 mesh;
7- 8043.35.12072 spring; 8 -
screw М3-3gх5.58А 016 GOST 1491-80;
9-
washer 3.65Г,016 GOST 6402-70; 10- 8043.35.12.520-01 drying envelope;
11 - 8043.35.12.071 filter; 12 - 8043.35.12.073 filter; 13 - 8043.35.12.143 filter;
14 - 8043.35.12.074 gasket; 15 - ring 036-044-46-2-3 GOST 9833-73/GOST 18829-73;
16 - ring 040-045-30-2-3 GOST 9833-73/GOST 18829-73;
17 - ring 120-126-36-2-2 GOST 9833-73/GOST 18829-73
Replacement of components
Perform a replacement using one of the repair kits below, depending on technical condition
of the components.
Repair kit 8673.00.00.00-03:
Vice