KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
96
Fig. 27 Adjustment of lower linkage rods
1
– rear hinge pivots; 2, 3 – lower rods;
4
– external stop; 5 – internal stop;
6
– stop; 7 – washer; 8 – bolt; 9 – platforms for
hydraulic hitch
–
fix lower rods 2 and 3 with each other, providing the size of 1165±1.5 mm between
lifting eyes of rear hinge pivots 1.
–
lift the linkage, providing for the distance of 1180...1280 mm from the supporting
surface to the lower rods; in doing so, the rods 2 and 3 shall be located between out-
er stop 4 and internal stop 5 (Fig. 27). Stops 744R3-46 28021-1, pos.6, shall be in-
stalled at the side of outer stops.
–
by means of moving washers 7 from under the head of bolt 8 under stop 6, if need-
ed, provide for the lateral movement of lower rods of 5 mm max.
5.1.2 Installation of light signalling equipment
CAUTION!
During final assembly of the tractor with regard to light signaling equip-
ment, it is necessary to thoroughly ensure that electrical harnesses and wires do not
touch sharp edges, moving parts of the tractor, and are not clamped against sharp
edges during erection operations.
Perform installation of light signaling equipment with the battery master switch switched off.
The front and rear service headlamps shall be mounted on the installation brackets at the
upper part of the cabin, fore and aft, respectively.
Rear service headlamps
ceiling harness
bracket
service headlamp