- 2 -
FOREWARD
First of all, we would like to take this opportunity to thank you for selecting our Dake V-26
model vertical Bandsaw.
As you know, the vertical bandsaw is a universal saw for contour cutting. Blade selection is
important and by choosing the right blade, you can make most any pattern cutting on most
any material with this machine. However, the most important thing is to realize how to
operate it in a safe and correct way and how to maintain it.
We have tried to supply you all the information about these. Please be sure to look through
all the contents in this manual so that you may obtain the maximum efficiency and the
longest machine life with minimum expense.
The specifications and information in this manual were current at the time this manual was
approved for printing. Dake, whose policy is one of continuous improvement, reserves the
right, however, to change specifications or design at any time without incurring obligations.
Always include the part number, model number, and parts description, for parts orders or
correspondence concerning your bandsaw, so we can supply you a rapidly after-sales
service.
1.
Read the operator’s manual carefully. Learn the tools applications and limitations, as well
as the specific potential hazards peculiar to it.
2. Always wear approved safety glasses/face shields while using this machine.
3. Make certain the machine is properly grounded.
4. Before operating the machine, remove tie, rings, watches, other jewelry, and roll up
sleeves above the elbows. Remove all loose clothing and confine long hair. DO NOT
wear gloves when operating.
5. Keep the floor around the machine clean and free of scrap material, oil and grease.
6. Keep machine guards in place at all times when the machine is in use. If removed for
maintenance purposes, use extreme caution and replace the guards immediately.
7. DO NOT over reach. Maintain a balanced stance at all times so that you do not fall or
lean against blades or other moving parts.
8. Use only sharp blades. Dull blades are dangerous.
9. Make all machine adjustments or maintenance with the machine unplugged from the
power source.
10.
Use the right tool. Don’t force a tool or attachment to do a job which it was not designed
for.
▲
WARNING
