9
10
2
5
Panel keys have been locked
When these blink, adjust by +/- 1 MHz
When the preset channel lamp
blinks, press the SET key twice to
display the frequency
When these blink, adjust by +/- 0.025 MHz
24
27
MHZ
MHZ
MHZ
27
預設頻道
Figure
5
Figure
6
Figure
7
Figure
8
Figure
9
Power Switch
5. Squelch Key
Presss
▲
,
▼
to adjust the squelch level between -10~+5; keeping the
▲
or
▼
keys pressed down
makes the sensitivity adjustment faster,Presss
▲
,
▼
to adjust the squelch level between -10~+5; keep-
ing the
▲
or
▼
keys pressed down makes the sensitivity adjustment faste.Pay attention to that the
larger the SQ value the shorter the operation distance will be.(Fig.5)
1. Turn on the power
(1) Press the Power switch to turn on the power to the
transmitter.
(2) To turn off: Keep pressing down the Power switch and
the power is off about 2 seconds later.
2. Adjusting frequency
# When setting the frequency as desired, make settings as 2-1 and 2-2.
2-1 When frequency is displayed on screen
(1) Press down SET key for 2 seconds.
(2) With the 3 digits on the left of the LCD blinking (Fig.7), press
▲
or
▼
keys to change the fre-
quency at an increment of “+/-” 1MHz (keeping the
▲
or
▼
keys pressed down makes the num-
ber change faster). Press SET key to set, and the 3 digits on the right of the LCD blinking (Fig.8);
press
▲
or
▼
keys to change the frequency at an increment of “+/-” 0.025MHz (keeping the
▲
or
▼
keys pressed down makes the number change faster). Press SET key to save the set value.
2-2 When setting your desired frequency while a preset channel is displayed on screen:
(1) Press down SET key for 2 seconds.
(2) The 3 digits on the left of the LCD begin to blink; press SET key twice to display the frequency
on LCD (Fig.9), now adjust the frequency by the same step of “2-1 When frequency is displayed on
screen – Point (2)”.
6. Lock key
When the setting of panel keys is complete, keep pressing the Lock key and after about 2 seconds the
panel keys are locked from being adjusted or set. To unlock, just keep pressing the Lock key for about 2
seconds. (Fig.6)
6-2 Setting the Mh-936K Handheld transmitter
