JTS US-36G2/5, Instruction Manual

13

English

7  Setting up a Transmission Path

1)  Set the transmission frequency on the re-

ceiver (

☞

 chapter 6 1 or 6 2)  If the transmit-

ter is still switched off and the LED bar graph 
RF (3) indicates reception, interference signals 
or signals from another wireless transmit-
ter are received  In this case, use a different 
transmission frequency 

2)  Switch on the transmitter and set it to the 

transmission frequency of the receiver (

☞ 

in-

structions of the transmitter)  The LED bar 
graph RF indicates the strength of the radio 
signal 

For detailed information on the display 

indications refer to the overview in chapter 1 

3)  Speak   / Sing into the microphone of the trans-

mitter or, when picking up the sound of an 
instrument, feed audio signals to the micro-
phone  Use the volume control (2) to match 
the output level of the receiver to the input 
of the subsequent unit 

The LED bar graph AF (4) indicates the 

volume level of the transmitter  Adjust the 
level on the transmitter, if necessary (

☞

 in-

structions of the transmitter)  

In case of no reception or poor reception, please 
check the following items:
– Are the batteries of the transmitter dis-

charged? The receiver indicates the battery 
status of the transmitter: 

☞

 chapter 1: Dis-

play 

–  Are there any objects interfering with recep-

tion in the transmission path? 

Keep the transmitter and the receiver at a 
minimum distance of 50 cm from any metal 
objects or possible sources of interference 
(e  g  electric motors, fluorescent lamps) 

–  Is it possible to improve the reception quality 

by turning the receiving antennas?

–  Is the transmission power of the transmitter 

too low (

☞

 instructions of the transmitter) 

and  /or the squelch too high (

☞

 chapter 6 4)?

8  Specifications

Carrier frequency range: 506 – 542 MHz
Audio frequency range:  50 – 18 000 Hz
Output level
  XLR, bal :                      120 mV 

(20 dB level attenua-
tion to be activated)

  6 3 mm jack, unbal :      70 mV 
THD:                                <  0 6 %
Dynamic range:                >  105 dB
Interference 
suppression:                    via pilot tone and 

adjustable squelch 
function

Power supply:                  via power supply 

unit provided and  
connected to 
230 V / 50 Hz

Dimensions:                    211 × 40 × 145 mm
Weight:                           1 kg

Subject to technical modification 

All rights reserved by MONACOR 

®

 INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may 

be reproduced in any form or by any means for any commercial use.