- 45 -
3) Add RTL command: set the command of RTL at the current GUIDED point;
4) Cruise around the GUIDED point: with the current GUIDED point as the central
point, the round air route point is plotted out and the GUIDED point is transformed into
interest point (if you manually set interest point in the instrument panel, or change the
head direction by remote, the head will no longer point to the encircling interest point);
5)Set repeated cruise: set the repetitive numbers and write to the UAV, and UAV can
automatically repeat this task before the command.
Note:
1.
Only one command is supported after one marked point, and if you cannot add a
new command, then mark another point;
2. After the landing command and RTL command is made, no more GUIDED point or
command can be added.
3. The order is executed in numbered order, and the head will point to the interest point
when it implements the GUIDED point newly added after the interest point.
GUIDED list
1) Enter GUIDED planning interface and you can generate GUIDED points on the map,
and add takeoff, LAND and RTL command and set interest point.
2) The above operation will generate the corresponding command in the GUIDED list
each command will have the corresponding parameters;
