Compact Kettle
Before first use
1. Remove any labels or swingtickets.
2. Wash the inside of the Kettle Body with liquid detergent and warm water, rinse and
dry.
3. Wipe the outside of the Kettle Body with a cloth, using liquid detergent and warm
water.
4. Wash the Lid in liquid detergent and warm water.
•
DO NOT IMMERSE ANY PART OF THE KETTLE IN WATER, EXCEPT THE LID .
5. Turn the Kettle upside down and use a screwdriver to set the Mains Voltage Selector
Switch to correspond to the mains supply voltage in your location, 110V or 230V.
•
IF YOU TRAVEL TO ANOTHER LOCATION, CHECK THE MAINS SUPPLY VOLTAGE AND, IF
NECESSARY, ADJUST ACCORDINGLY. FAILURE TO DO SO MAY RESULT IN DAMAGE TO
THE KETTLE.
6. Follow the “How to use” instructions to boil the maximum amount of water, then discard
the water.
How to use
1. Position the Kettle on a dry, level and stable surface, away from direct heat.
2. The Mains Lead should be positioned so as not to cause an obstruction or to overhang
the edge of the surface. The Kettle should not be positioned directly below a mains socket.
3. Remove the Lid .
4. Pour the required amount of cold water into the Kettle, ensuring that the level is below
the MAX 0.5l mark.
•
DO NOT OVERFILL, OR USE WITH LESS THAN A CUP FULL OF WATER.
5. Replace the lid .
6. Insert the Mains Plug into a mains socket and switch on at the socket.
7. Flick the Off/On Switch down to begin to heating the water.
•
When the water has begun to boil, the Kettle will switch off automatically and the
Indicator will extinguish.
8. Switch off the mains socket and remove the Mains Plug .
9. Pour water from the spout of the Kettle, as required.
•
TAKE CARE WITH VERY HOT WATER.
•
Once the water has cooled, it can be reheated by flick the Off/On Switch down. This will
not function while the water is still hot.
•
THE KETTLE HAS OVERHEATING PROTECTION, WHICH WILL AUTOMATICALLY SWITCH
IT OFF. HOWEVER, YOU SHOULD TAKE CARE NOT TO ALLOW IT TO BOIL DRY.
