Food Processor
How to assemble
Ensure that the machine is disconnected from the electricity supply before
assembling or changing any inserts.
1.
Insert the Feed Head
2
into the Drive Socket
6
of the
Motor Body
1
, angled to the right, as indicated in the
diagram. When you feel it slot “home”, rotate counter-
clockwise into a vertical position until it “clicks” into
place.
2.
Select the required Insert
4
according to your
requirements and to the following guidelines:
•
Red - suitable for coarse grating of: carrots, courgettes,
potatoes, peppers, hard cheese (e.g. Parmesan) or
chocolate;
•
Orange - suitable for fine grating of: carrots,
courgettes, hard cheese (e. g. Parmesan), chocolate or
coconuts;
•
Yellow - suitable for grinding/grating of: hard cheese (e. g. Parmesan),
chocolate, dry bread/rolls or pastries, hazelnuts, walnuts, almonds or
coconuts;
•
Light green - for cutting thin, smooth slices. This insert is suitable for cutting:
carrots, courgettes, potatoes, cucumbers, peppers, onions, turnips, red
cabbage, white cabbage, apples or hard cheese;
•
Dark green - for cutting thick, wavy slices. This insert is suitable for cutting:
carrots, courgettes, potatoes, cucumbers, peppers, onions, turnips, red
cabbage, white cabbage, apples or hard cheese.
DO NOT USE THE FOOD PROCESSOR FOR PROCESSING VERY HARD FOOD
OR MEAT
3.
Slide the selected Insert
4
over the drive shaft in the Feed
Head
2
.
THE CUTTING AND GRATING SURFACES OF THE INSERTS
ARE SHARP; TAKE CARE WHEN HANDLING AND HOLD
ONLY BY THE PLASTIC PARTS OF THE INSERTS.
4.
Place the Insert Fastener
5
on the end of the drive shaft
in the Feed Head
2
, then turn counter-clockwise until it
“clicks” into place.
