12
JUDO BIOSTAT-COMBIMAT
Installation
The profile of the profiled flange gasket must
face towards the bypass valve
Failure to observe this can lead to leaks and
water escaping. This can cause damage
due to water to the house and installations.
4.3
Discharging the flushing water
An adequately dimensioned wastewater
connection (e.g. floor drain) according to
local regulations must be available for the
flushing water.
The dimensioning depends on actual
requirements on site (e.g. wastewater pipe
gradient, number of pipe bends, length of
the waste-water pipe, etc.). The dimen-
sioning must at least ensure that all the
wastewater can be discharged adequately
and safely.
If it is not possible to locate a drain connec-
tion directly under the water treatment
device, the wastewater hose can be routed
over the water treatment device.
The wastewater hose for the flushing water
must be led to the drainage channel without
any kinks. The loose end of the hose has to
be firmly fixed with the included adhesive
tape at the pipe or a similar object.
In all options, a free discharge must be
ensured in accordance with DIN EN 1717.
The flushing water must be discharged into
a firmly mounted drain.
Flushing water discharge options
Ensure that the wastewater
connection functions before plug-
ging the power supply unit into the
socket.
Fig. 9: Flushing water discharge options
> 20 mm
ø 50 mm
> 150 mm
