Juguetronica BRICK DRONE, Manual

DEPARTURE

WARNING

Connect the battery to the drone, the front LEDs will continue to flash. Turn the transmitter on, 
move the left joystick up, and then push it down to synchronise the drone.
When you hear a beep, it means the transmitter has been correctly synchronised with the 
drone, and the LEDs will stop blinking.

1. If the transmitter's LED stays on but the drone LED is flashing slowly, synchronisation has 

not been performed correctly. Turn off both the transmitter and the drone, and start the 
procedure again from the beginning.

2. If once in the air the drone does not remain stable, land it and turn off both the transmitter 

and the drone. Then, resynchronise it, making sure the drone is placed on a flat and 
horizontal surface while you do so.

3. If the drone LED blinks slowly, the battery is running low. Land it and charge the drone battery 

with the supplied USB charger. 

When the drone is flying uncontrollably and it becomes impossible to make a trim that corrects 
these errors (see p. 9 for more information on trimming), it is best to perform a factory reset so 
that the drone returns to its default settings.

Posición

horizontal

TIP:

Make sure your Brick Drone is on a flat  horizontal surface during 
the synchronisation procedure, so the flight is stable.

Land the drone on a flat surface. Then move 
the left joystick to the lower right corner and 
the right joystick to the lower left corner (move 
them both at the same time). The two front 
LEDs will stop blinking and remain fixed.
Another option is to press and hold the reset 
button for 3 seconds. When the transmitter 
emits a beep, the calibration has been 
completed.

CALIBRATION

DRONE SYNCHRONIZATION