– 87 –
(2) checking the contour of a sewing pattern
1) Press
key to make the READY LED
lght up.
2) Select the "INTERMEDIATE PRESSER"
wth
key.
3) Lower the work clamp feet wth the foot
swtch.
the sewing machine does not start
even when the foot switch is de-
pressed under this mode.
4) Press
key n the state that the work
clamp feet are lowered.
the work clamp feet do not go up
even when the foot switch is de-
tached.
5) Confirm the contour of the pattern with
key or
key.
6) The work clamp feet wll go up when
key
s pressed.
WarnInG :
Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp feet during sewing, causing dangerous troubles including needle breakage.
8
Finish of setting
1) Press the
key.
2) After the work clamp feet have moved and gone
up, the sewng LED lghts up, and the sewng s
ready.
1. When the data is changed, press
to confirm the change.
2. When selecting the items of the height of the intermediate presser and the bobbin
winder, the machine cannot move to the sewing state. select other items.
3. If
key is pressed, you can make sure of the respective setting items again. How-
ever, the items can not be changed in the state that the sEWInG lED is lit up.
4. When
key is pressed, the rEaDY lED goes off. set values of the respective
items can be changed.
5. thread tension can be changed even when the sewing lED lights up.
6. Use the machine after confirming the pattern No. When
key is pressed while
pattern no. is indicated "0" (state at the time of delivery), error display E-10 appears.
at this time, re-set the pattern no.
7. change of the height of the intermediate presser and the bobbin winder fail to work
immediately after turning on the power. use the machine after pressing rEaDY key
and performing the origin retrieval.
h
h
d
e
