P 5
P 1
P 2
P 3
P 4
P 5
P 1
P 2
P 3
P 4
P 5
5) CP-5 (Output check)
1. Operation
– 146 –
6) CP-6 (Presser and thread trimmer motor / origin sensor check)
The status of inching operation of the presser and thread trimmer motor, operation of origin retrieval, and the
presser origin and thread trimmer sensors is displayed.
1. READY operation
In the first place, press the key for the origin retrieval of the needle thread clamp.
After operation for preparation, the sewing LED is lit.
2. Operation
The key is used to drive the presser and thread
trimmer motor to each preset position.
1
Presser lifting position
2
Presser lowering position (lowering position during
pedal operation)
3
Thread trimmer position
4
Presser lowering position (lowering position after
thread trimming)
When the key is pressed while the key is
kept pressed, the motor is driven reversely.
According to the status of the thread trimmer sensor, “0” or “1” is displayed.
The checking items can be changed with the and
keys.
In regard to the items, refer to the section of IP-400 output
check.
An output is generated while the key is pressed.
According to the status of the presser origin sensor, “0” or “1” is displayed.
Using the and keys, the presser and thread
trimmer motor can be driven by one pulse in the +/– di-
rection.
The START Switch is used for the origin retrieval of the presser and thread trimmer motor.